Hello everyone! I am hoping someone else has experienced the same thing or something similar to what I am about to explain. I have the Melco bravo amaya. So, I first started with the slimline 1 and I LOVE it and have had no problems.
Today, my slimline 2 chassis, melco adapter and 12x9 frame came in. I followed all installation instructions thoroughly.
What I'm trying to figure out is If anyone with this size clamp experienced the front of the window dropping down and then getting caught on the sewing arm at the end where the bobbin is when it is moving back. I know I will rarely have a design that it will have to go back that far, but I'm just trying to see if there is a fix. It seemed that the hoop was fine before I did the test stitch and then it "dropped." I am so nervous about this large clamp and don't want to mess up anything.
Thanks in advance!
Today, my slimline 2 chassis, melco adapter and 12x9 frame came in. I followed all installation instructions thoroughly.
What I'm trying to figure out is If anyone with this size clamp experienced the front of the window dropping down and then getting caught on the sewing arm at the end where the bobbin is when it is moving back. I know I will rarely have a design that it will have to go back that far, but I'm just trying to see if there is a fix. It seemed that the hoop was fine before I did the test stitch and then it "dropped." I am so nervous about this large clamp and don't want to mess up anything.
Thanks in advance!
Comment