Announcement

Collapse
No announcement yet.

After maintenance issue

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • After maintenance issue

    I have an XT that I just completed maintenance on, needle case is now all the way to the left (on needle 1) with the needle descended into the needle plate. I needed to take off the black plate on the right hand side (the one with 5 screws) to do the maintenance, replaced it loosely with no problem. When maintenance was complete and I tried to return to sewing, needle 1 came down and will not move when machine is activated.
    Seems that I had this issue before and it turned out to be a software problem that can be quickly fixed if I could only remember the procedure!
    Any help or advice is greatly appreciated! Like most of us, I have a large project that should be finished by tomorrow!
    Many thanx, Mike

  • #2
    See if this thread sheds any light:

    Comment

    Working...
    X