Announcement

Collapse
No announcement yet.

3d puffy foam questions

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • 3d puffy foam questions

    hello all, I have a small story to tell with a few questions afterwards.

    here at our shop we have been working with 3d puff for a few months now and we cannot seem to get it right. We had an offer to do a job on flex fit hats it is a relatively simple design, just 3 large letters in puff on top of a flat fill/outline. we have adjusted all the settings in the operating system and also had the design digitized twice so we know it is us now and not the digitizing that is the problem. Does anyone have a recommendation for what has absolutely worked best for them as far as settings. what were the upper and lower limits you used? what was the presser foot setting? What was the backing used? What needle and anything else that might apply to help us out?

    We really want to offer 3d puff designs to our customers because not many people in our area do it in house if any at all.

    Thanks all for your time,
    Michael Iarocci
    The Max Screen Printing & Embroidery
    759 Lakeshore Blvd.
    Painesville, OH 44077
    [email protected]
    Work: 440-357-0036
    Mobile: 440-862-3068

  • #2
    Can you describe what issues you are having?
    Herb<br />Royal Embroidery

    Comment


    • #3
      *set the presser foot height first
      *set the actifeed to about 9 or 10 manual
      and test it out

      Comment

      Working...
      X