I was doing my maintenance and when you take the black cover off the right side and lift up the lever and grease it, I did as was asked. Then I put the cover back on and pressed OK. But for some reason it could not complete it. The #1 needle is down and the presser foot is above it. What did I do and how do I fix it? Thanks - mary
Announcement
Collapse
No announcement yet.
20.000.000 maintenance prblem
Collapse
X
-
I had the same issue with this maintenance....I wasn't around when everything was sorted out, but basically the needle bar got jammed under that black thing we had to put grease on and it just needed to be moved out from under that so it could move freely again. I'm not sure how it got stuck underneath it as we were being cautious about doing it since it was the first time performing this maintenance. Any way, I hope everything gets sorted out quickly. Good luck
Comment
Comment