I have been running a job that I have run many times before. I have gone through 1 pak of needles and tons of thread breaks. Did a full maintenance, replacing the red and yellow rollers and the little black thingy, and greased and oiled everything. No Maintenance left undone. Didn't help, so redigitized the design. That didn't help either.
I did a bottom down and see that the needle is not exactly in the center. It is about half a needle width to the right which makes it almost, but not quite, touching the right side of the hole. That was on needle 1. I also checked needle 2 - same thing. This could be the problem - maybe.
So, how do I adjust this?
Merry Christmas - Ho, Ho, Ho
Juli in Kona
I did a bottom down and see that the needle is not exactly in the center. It is about half a needle width to the right which makes it almost, but not quite, touching the right side of the hole. That was on needle 1. I also checked needle 2 - same thing. This could be the problem - maybe.
So, how do I adjust this?
Merry Christmas - Ho, Ho, Ho
Juli in Kona
Comment