Today, sewing caps, had run 5 of 16, no problems. All of a sudden, in the middle of the sew out, it stops, needle down, screen goes grey, nothing. Turned it off, all the things I could think of. Called Melco, talked to Sal, turns out the emergency stop was engaged.....hummmmm....I'm not working by the machine, I'm trimming the other cap....so, turn the em stop, starts up, and goes thru all the steps as when at the beginning of sewing a design, but goes back to where the design/logo stopped, starts again and finishes the design....good...then exactly the same thing happens again, happened each time on 2 more caps, started, stopped, started. Even snapped 2 needles...
Took off the cap frame, sewed flats....perfect.
What is up with this??? 11 more caps to do, checked into a glitch in the design, nothing, loaded, unloaded.
Any suggestions?
Thanks,
Susan
@Hidden Cottage
Took off the cap frame, sewed flats....perfect.
What is up with this??? 11 more caps to do, checked into a glitch in the design, nothing, loaded, unloaded.
Any suggestions?
Thanks,
Susan
@Hidden Cottage
Comment