I just purchased a slightly used Amaya Xts. I set it all up with the ethernet hub, forced download checked and all that good stuff. When I turn it on, I get a humming noise, but no lights or movement, and needle number one is stuck down.
It was giving me no ethernet connection error but I changed the setting to run my Windows 7 as XP, which is how I have my ENS and EMT-10T-F1's set up fine. Now I don't get that message any more but it's not connecting to my computer. I've read discussions all night and I can't figure it out.
The Emergency button is not pushed.
When I go to configure machines, there are none that show up.
Any suggestions??
It was giving me no ethernet connection error but I changed the setting to run my Windows 7 as XP, which is how I have my ENS and EMT-10T-F1's set up fine. Now I don't get that message any more but it's not connecting to my computer. I've read discussions all night and I can't figure it out.
The Emergency button is not pushed.
When I go to configure machines, there are none that show up.
Any suggestions??
Comment