Announcement

Collapse
No announcement yet.

OS v10 Turning Bobbin Detection On Automatically

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • OS v10 Turning Bobbin Detection On Automatically

    Using Amaya OS Flex+ Version 10.00.051, Windows 8.

    We are running caps we have two XT machines running same sew out on the same substrate. We have manually turned off the bobbin break detectors off on both machines. Machine A stops every few hundred stitches for a false bobbin break whilst Machine B sews through no problem. When Machine A stops we go to settings and the bobbin detector is back on again, so we switch it off, click apply then OK and start sewing. Repeat...

    Only one machine does this and it is annoying. Anyone else come across this?

  • #2
    This may seem like a no-brainer, but do you hit the Apply key when you turn off the bobbin detector? Sometimes the changes I make in Properties stay put without doing this, sometimes not.

    Comment


    • #3
      I did hit apply, it was mentioned in my original post. This just started happening over the last few weeks, we have restarted the machine as well.

      Comment

      Working...
      X