Using Amaya OS Flex+ Version 10.00.051, Windows 8.
We are running caps we have two XT machines running same sew out on the same substrate. We have manually turned off the bobbin break detectors off on both machines. Machine A stops every few hundred stitches for a false bobbin break whilst Machine B sews through no problem. When Machine A stops we go to settings and the bobbin detector is back on again, so we switch it off, click apply then OK and start sewing. Repeat...
Only one machine does this and it is annoying. Anyone else come across this?
We are running caps we have two XT machines running same sew out on the same substrate. We have manually turned off the bobbin break detectors off on both machines. Machine A stops every few hundred stitches for a false bobbin break whilst Machine B sews through no problem. When Machine A stops we go to settings and the bobbin detector is back on again, so we switch it off, click apply then OK and start sewing. Repeat...
Only one machine does this and it is annoying. Anyone else come across this?
Comment