I am very new to embroidery & this is my first post. I have a hat order that is giving me problems. I have a 6 panel structured 100% Acrylic hat with a 4in x 1in logo at 5894 stitch count. I get a lot of thread breaks but my biggest issue is there are three red lines and I'm getting the bobbin thread to show thru throughout the line. I have the hat hooped as tight as I can get it & am following the video I watched by Herb. I have it set to Auto and have tried material thickness from 6 to 10, tried the column feed from 40-50, have the lower limit set from 6-8. Tried 1 piece of backing and 2, speed set from 800-950. Changed the needle (not in backwards), changed the thread, changed the position of the thread on machine. I do not do digitizing but had it done by 2 different places ( sewing center out) both giving me bobbin thread in line. I tried on Manual once with material thickness at 8 and lower limit at 6. Had fewer thread breaks but same issue with bobbin in the line. I need help to see what I am doing wrong, running out of extra hats.
Thank you!
Thank you!
Comment