Hi!
I have a Amaya XT that is about 10 yrs old and I have been having trouble with it lately.
It started with shutting down on its own but leaving the main light on. It would finish a design and then refuse to do anything else. It wouldn't load a design, it wouldn't change threads, even the emergency stop didn't work. After i shut down and restarted the machines and the computer it would turn on again. After that I had trouble loading designs. it would say that the sew was not complete but it wouldn't let me reset the design. I can't move it to any part of the design because when I click on the settings tab a pop up block comes up that says i need to enter an integer between 0-25 and it keeps popping up if i try to go to another tab.
Now it will load a design (after a few shut downs and restarts) but it won't finish the design. The needle just goes up and down without the arms moving or the thread feeders moving.
any suggestions would be fantastic! thank you
I have a Amaya XT that is about 10 yrs old and I have been having trouble with it lately.
It started with shutting down on its own but leaving the main light on. It would finish a design and then refuse to do anything else. It wouldn't load a design, it wouldn't change threads, even the emergency stop didn't work. After i shut down and restarted the machines and the computer it would turn on again. After that I had trouble loading designs. it would say that the sew was not complete but it wouldn't let me reset the design. I can't move it to any part of the design because when I click on the settings tab a pop up block comes up that says i need to enter an integer between 0-25 and it keeps popping up if i try to go to another tab.
Now it will load a design (after a few shut downs and restarts) but it won't finish the design. The needle just goes up and down without the arms moving or the thread feeders moving.
any suggestions would be fantastic! thank you
Comment