I am having the most irritating problem lately. Within the last 4 months, my Amaya XT absolutely will not stitch with Rayon thread. Polyester has no issues whatsoever. The machine will stitch between 6 and 30 stitches and the Rayon thread simply snaps.
Listed below are the steps we have taken to try and resolve this:
I am nearly at the hair pulling stage. And am open to whatever suggestions the community can throw at me.
I really appreciate your help!
Matt
Listed below are the steps we have taken to try and resolve this:
- Replaced/Readjusted Bobbin
- Replaced Thread Spools
- Replaced Needles
- Replaced rubber thread feed wheels
- Replaced red thread feed wheels
- Reset timing (twice) - not because timing was wrong, just to remove it from the equation
- Reset thread feed gear spacing
- Adjusted thread feed settings to try to optimize performance
- Replaced thread break detection assembly and circuit board
I am nearly at the hair pulling stage. And am open to whatever suggestions the community can throw at me.
I really appreciate your help!
Matt
Comment