Hello I am fairly new to the digitising world but I have been doing it for about 3 months now and steadily learning tips and tricks. I have seen some deigns which have a gradient fill. For example at one end a solid red which ends up being a yellow at the other. I have design shop pro 9, and I don't think there is a tick box to have the software do it for you, unless I have missed it.
I have had a try with a pair of sunglasses which had black in one corner which faded up to a silver to give a reflective look. I did it by splitting the lense into four sections each with a diffierent thread density. Where the area need to be black I sewed out at about .38 and at the other end it was above 1 but with the opposite values for the silver thread so this showed through. The initial sew out was not too bad, but not quite a smooth transition. Just wondered how others did it?
I have had a try with a pair of sunglasses which had black in one corner which faded up to a silver to give a reflective look. I did it by splitting the lense into four sections each with a diffierent thread density. Where the area need to be black I sewed out at about .38 and at the other end it was above 1 but with the opposite values for the silver thread so this showed through. The initial sew out was not too bad, but not quite a smooth transition. Just wondered how others did it?
Comment