Announcement

Collapse
No announcement yet.

Emt16

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Emt16

    Hello everyone,
    I just purchased a EMT 16 and I have a lot of questions. I have a big red and I'm used to watching the thread bounce down at the bottom and I can adjust the thread feed if i see it flailing around everywhere. I can't do that with the EMT 16 because of the felt pieces along the front bottom of the machine. When I do a design on the emt 16 and set the material thickness the same as I do on big red it seems the thread will run very tight on new machine. So I guess my question is does emt 16 run tighter thread usually than big red?
Working...
X