Good evening,
I was in the middle of sewing a design and came to a color where the thread was out of the feeder wheel. By the time I figured out what was happening, the needle ended up breaking so I replaced it and cleaned the bobbin area, spun the bobbin a few times and did a "head up" as is recommended. All looked normal. However, when I went to back up the design a couple of stitches to start sewing again the machine immediately moved to the #1 needle and the needle bar and footer dropped down and froze. Now every 30 seconds or so it "comes to life" with the light coming on and tries to reset but falls back to down position. I was able to remove the #1 needle to get the hoop out but now when I turn the machine on it keeps repeating this.
Any after hours advice?
Thanks,
Steve
I was in the middle of sewing a design and came to a color where the thread was out of the feeder wheel. By the time I figured out what was happening, the needle ended up breaking so I replaced it and cleaned the bobbin area, spun the bobbin a few times and did a "head up" as is recommended. All looked normal. However, when I went to back up the design a couple of stitches to start sewing again the machine immediately moved to the #1 needle and the needle bar and footer dropped down and froze. Now every 30 seconds or so it "comes to life" with the light coming on and tries to reset but falls back to down position. I was able to remove the #1 needle to get the hoop out but now when I turn the machine on it keeps repeating this.
Any after hours advice?
Thanks,
Steve
Comment