Quantcast HELP!!!!!! Replacing clamp on an XT cap driver HELP!!!!!

news

discussion boards mailing list tips / tricks / forms designs suppliers find a shop marketplace
News
  archives

Discussion
  main menu

Suppliers
  apparel
 
hats
 
thread
  backing
  hoops / hooping
  stock designs

Tips & Tricks
  main menu

Mailing List
  sign up now
 
my account

Amaya Shops
  locate a shop

Marketplace
  shop for supplies

Resources
  official Melco site
  online resources

 

Help Support This Site:


 


 

Results 1 to 2 of 2
  1. #1
    Join Date
    Aug 2006
    Location
    Eureka, California
    Posts
    659
    Post Thanks / Like

    HELP!!!!!! Replacing clamp on an XT cap driver HELP!!!!!

    Because I work when I am half asleep, I changed from embroidering a flat to embroidering a cap. I set the cap driver on. I hit trace. I found out I forgot to upload the cap design, and traced the flat design, which was too big for the cap driver and resulted in a broken clamp on the right side. I ordered the clamps from Melco and have them in possession. Any tips or tricks I should know?

    AND ESPECIALLY....WHAT DO I USE TO UNSCREW THE NUTS HOLDING IT IN? THEY LOOK ROUND ON THE INSIDE!

  2. #2
    Join Date
    Aug 2006
    Location
    Eureka, California
    Posts
    659
    Post Thanks / Like
    The answer is it takes a hex wrench from the tool set. Undo the screws, take off old clamp, pop on new clamp, tighten. Adjust the nuts/bolt on the end with a 9mm box-end wrench.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
  a Levelbest Network Site - 2013

This site is not owned by or affiliated with Melco or any companies or subsidiaries.