I was trying to start up my two Melco Amayas and I am getting message above where the I can load one machine but not the other. Has anyone ever had this problem. Any information/advice is greatly appreciated. Thank you.
Announcement
Collapse
No announcement yet.
Denied Cluster Message
Collapse
X
-
Check the connection from your hub(switch) to the malfunctioning machine. Unplug it from the port on the hub as well as the machine and plug them in again. This will exercise the pins in case of some possible corrosion. Also you might just plug the machine Ethernet cable into a different port on the hub.
To check for a bad Ethernet cable, swap the good machine cable to the malfunctioning machine and see if the computer will recognize it.
See if this helps as starters..
Rod Springer
Amaya Tech & TrainerCertified tech & trainer<br />208-898-4117
Comment