Tweet
I recently had an accident with leaving the slimline frame open. At start up the frame grabbed the needlecase and pulled it loose. Could not get a tech soon enough so called in a baruden repairman. With my instructions he was able to get it on. Machine ran, he left and I was not satisfied with the outcome. Along with the service repair instructions from website I removed the case and put it back on the machine. Trimmed the hook, calibrated the needles and away we go. That was about 2 months ago. Now I hear a thumbing noise behind needlecase. It is all needles. If I stitch a satin row if 1000 stitches it will bump about 5 or 6 times consistently. Getting a tech is unbelievably hard and expensive. Any advise on where to look. I am not afraid to try.
- Attention New Users - this forum is MODERATED!
All registrations are checked by a live human being to prevent spam and may take a few minutes to a day or two be approved. We thank you in advance for your patience and look forward to having you be part of our community!
Comment