Announcement

Collapse
No announcement yet.

Need a little help

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Need a little help

    First off, let me say that I only have DesignShop Lite, so digitizing (or fixing it) myself is basically out of question. I have sewn out the TC by itself with no problem, but once I add it to the applique design (I did have to make it a bit smaller to fit), the outline sewed out a little off. It appears that it's the fill and not the outline, but I could be wrong.

    Is there any way I can easily fix this? Is it a push/pull compensation setting? Any input would be GREATLY appreciated.

    Thanks!

    Scott
    Attached Files

  • #2
    I would say it is caused by pull as the distortion is in the direction of the fill.

    Is the original design file in OFM?

    You can send it to me and I will try to make the adjustments for you in clude this photo also.

    You are using a cutaway backing when sewing this correct ?

    if not you need to, with all the layers it will lessen the distortion.
    [email protected]
    Jerome in Minnesota
    (320)259-1151

    Comment

    Working...
    X