First off, let me say that I only have DesignShop Lite, so digitizing (or fixing it) myself is basically out of question. I have sewn out the TC by itself with no problem, but once I add it to the applique design (I did have to make it a bit smaller to fit), the outline sewed out a little off. It appears that it's the fill and not the outline, but I could be wrong.
Is there any way I can easily fix this? Is it a push/pull compensation setting? Any input would be GREATLY appreciated.
Thanks!
Scott
Is there any way I can easily fix this? Is it a push/pull compensation setting? Any input would be GREATLY appreciated.
Thanks!
Scott
Comment