Hello all,
We have an Amaya XT that was stitching fine earlier today. All of a sudden in the middle of a design it became extremely loud while it was stitching like something was pounding or grinding and then it abruptly stopped. I ran a maintenance check on the rotary hook and a 2mil stitch interval oil check and it worked ok. I restarted / lined up my design and when it started the same issue happened. It doesn't get loud until it starts going up to speed (I have it set on 950spm). Any suggestions?
Thank you all,
Mike @ The Max
We have an Amaya XT that was stitching fine earlier today. All of a sudden in the middle of a design it became extremely loud while it was stitching like something was pounding or grinding and then it abruptly stopped. I ran a maintenance check on the rotary hook and a 2mil stitch interval oil check and it worked ok. I restarted / lined up my design and when it started the same issue happened. It doesn't get loud until it starts going up to speed (I have it set on 950spm). Any suggestions?
Thank you all,
Mike @ The Max