I'm using Design Shop Pro+ version 10, and the OS is Amaya OS Flex+ version 10.00.051
When I put the slim-line clamping frame on my XTS, and center the hoop to the machine, the X position is 0, but the y position is -156.
The clamp I'm using is 6.5 x 5, but it currently does it with all slim-line clamps that I've tried today.
I centered the design in DesignShop before sending it to the machine.
Centered the design also in the OS and then centered the hoop to the machine.
The actual physical hoop does appear to be centered.
I'm not sure if it has always been like this and I just didn't notice? Or ?
If I change from slim-line hoops to any other hoop (say the mighty 5.5 x 5.5) and center to machine, x and y are both 0.
Is this normal? What am I doing wrong?
Many thanks,
Joanie
Sew Many PawsAbilities
When I put the slim-line clamping frame on my XTS, and center the hoop to the machine, the X position is 0, but the y position is -156.
The clamp I'm using is 6.5 x 5, but it currently does it with all slim-line clamps that I've tried today.
I centered the design in DesignShop before sending it to the machine.
Centered the design also in the OS and then centered the hoop to the machine.
The actual physical hoop does appear to be centered.
I'm not sure if it has always been like this and I just didn't notice? Or ?
If I change from slim-line hoops to any other hoop (say the mighty 5.5 x 5.5) and center to machine, x and y are both 0.
Is this normal? What am I doing wrong?
Many thanks,
Joanie
Sew Many PawsAbilities
Comment