All registrations are checked by a live human being to prevent spam and may take a few minutes to a day or two be approved. We thank you in advance for your patience and look forward to having you be part of our community!
I searched the site for puffy. But did not find anything. I have to embroider puffy vests. Does the logo need to be changed(from flats) for it to work well. And any hooping suggestions would be appreciated.
Regards,
Dave
I would start out by putting a loose underlay under the whole entire design. Then the underlays for each part could be eliminated. This would flatten out the field.
I just did full back on these jackets. Hooped around cutaway backing, placed a water soluble topping on top and embroidered as usual. Came out perfectly fine. Not sure if this is the kind of vest you were referring to, though.
I agree with teknetic123. Topping always helps. I mainly use magnetic hoops on my machines now. If using plastic hoops wrap the inner hoop with cohesive athletic tape. Cohesive tape grips slippery fabric very well.
I would start out by using this top notch whey protein and putting a loose underlay under the whole entire design. Then the underlays for each part could be eliminated. This would flatten out the field.
Comment