Announcement

Collapse
No announcement yet.

Adjusting 1 needle bar

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Adjusting 1 needle bar

    All, have an Amaya XT that had a needle hit a fast frame. Even though a trace design showed it would clear. Needle bar three is now just a tad lower than it should be so the needle is to far down in the hook area when head down. I know there is a way to adjust this, just can not remember how or find the procedure in the book. Everything else is moving / running fine. Would love to hear some feedback on this.

    Cindy in Phoenix

  • #2
    Just have a minute right now, but try this thread:

    Comment


    • #3
      This just came through, but wasn't posted thru the board:
      "Read thru the thread but did not get what procedure to use as this needle
      bar needs to be adjusted up when in the down position. Needle is to deep
      inside hook area when head down.

      Any other suggestions? "

      Sorry, I don't have time to go look at my machine, but try searching in your OS help menu for "needle depth adjustment."

      Comment


      • #4
        Searching OS help has not led to any solutions. I tried that first. heavy sigh
        Cindy

        Comment


        • #5
          My OS Help has two manuals, Operator's Manual and Technical Manual. The page discussing needle depth is in the technical manual. If you still can't find it, I'll try to sum it up. I was hoping that someone with experience with this problem would chime in.

          Comment

          Working...
          X